vent control buttons
Moderators: Helpinators, Moderators
vent control buttons
Any one have a stuck in on position defroster vent control button? How do I fix ? Right now only the defrost vents will blow.
-
kimokalihi
- Fifth Gear
- Posts: 8360
- Joined: Mon Nov 06, 2006 3:41 am
- Location: Tenino, WA
Re: vent control buttons
You have to get under the dash and mess with the gears and arms that control the vent. They're either binded or need grease or your motor is dead.
98 Metro Hatch Daily Driver :)
91 SS EJ20G Engine/Tranny/Diff Swap Build Thread Here
"Your testes are close to your bottom but you still play with them all the time." Jeremy Clarkson
91 SS EJ20G Engine/Tranny/Diff Swap Build Thread Here
"Your testes are close to your bottom but you still play with them all the time." Jeremy Clarkson
Re: vent control buttons
I am actually diving into thethe same problem tomorrow. Will let
you know what I find out.
you know what I find out.
Re: vent control buttons
The solder joints on the HVAC controller are probably cracked. Check out this thread.
http://bbs.legacycentral.org/viewtopic.php?f=10&t=1142
http://bbs.legacycentral.org/viewtopic.php?f=10&t=1142
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
Re: vent control buttons
I did perform the above recommendation. I soldered the contacts that looked cracked or had hairline cracks under a magnifying glass. Put most of the dash back together and no luck. So I laid under the steering wheel while changing buttons and heard my motor try to switch and would sloowwwlly wind down. It is most likely one of the two issues in your case.