Check engine light

93legacySS · Post by **93legacySS** » Sat Jun 14, 2014 6:33 pm

I read my codes and all but I was wondering if it's ok to leave the black connectors unplugged or do you have to have them together?

mike-tracy · Post by **mike-tracy** » Sun Jun 15, 2014 2:46 am

When driving around normally you leave them unplugged.

93legacySS · Post by **93legacySS** » Sun Jun 15, 2014 5:58 am

The black ones like I said correct? Because they were plugged in when I got under there

mike-tracy · Post by **mike-tracy** » Sun Jun 15, 2014 7:07 am

There are two black ones under the dash. One set with a stripe and smaller connector, those stay plugged in. The all black ones stay unplugged.

wtdash · Post by **wtdash** » Sun Jun 15, 2014 4:29 pm

+1 and the ECU code-reading plugs should be just one wire on each connector. The other one is part of the seat belt lights and/or warning (I was just messing w/this last week!).
TD

James614 · Post by **James614** » Mon Jun 16, 2014 3:56 am

wtdash wrote:The other one is part of the seat belt lights and/or warning (I was just messing w/this last week!).
TD

Is this why my seatbelt light has been flashing ever since my swap?

wtdash · Post by **wtdash** » Mon Jun 16, 2014 4:08 am

^ Probably...mine got unplugged and was blinking, too.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Check engine light

Check engine light

Re: Check engine light

Re: Check engine light

Re: Check engine light

Re: Check engine light

Re: Check engine light

Re: Check engine light