Pressure Plate to Flywheel bolts?

[skid542]

This may a bit of a noob question but... my new flywheel and clutch arrived today (along with my Grp N mounts - woot ) and it occured to me, do I need to source a set of bolts to mate the pressure plate to the flywheel. It's been a while since I pulled my parts car apart and I can't remember if I'll get the bolts I need from taking off the flexplate?

I know the bolts from the flex plate to the crank will be re-used for the flywheel to the crank, but with the other bolts work for the pressure plate to the crank?

Simple question I know, but I didn't want to get caught on this with my pants down so to speak.

And while I have your attention... are all the thread sizes on the slave and master cylinders the same? i.e. I need to get a hose to join the two and want to get a braided line and am not sure what length and fittings I need at the end.

Thank you in advance.

[Legacy777]

You will need the bolts to bolt the PP to the flywheel.

[skid542]

Care to provide any info such as bolt dia. and pitch?

Or a step better, P/N?

Thanks.

[skid542]

Mods, I now have this information and have added it to my other all inclusive thread on my swap.

Please delete this thread.

[Legacy777]

For archival purposes, here's a link to information answering original question.

http://bbs.legacycentral.org/viewtopic. ... 451#282451