What did you do to your Subie today?

Danny-G · Post by **Danny-G** » Sun Mar 02, 2014 7:42 pm

Here's the result of my painting.

92ColoradoTurbo · Post by **92ColoradoTurbo** » Tue Mar 04, 2014 4:02 am

PREPARE FOR PHOTOS!

Discovered that my low fuel light works! I'm guessing it comes on when you have two gallons left because I drove to the gas station with it on for a bit and filled up 14.1gal and we have a 15.8gal tank I believe. Also took her on a road trip to Tarryall Reservoir, Colorado.

Sent from my XT1080 using Tapatalk

Scuba75 · Post by **Scuba75** » Tue Mar 04, 2014 4:22 am

Replaced all four struts and mounts on my 93 wagon with KYB G2's, plus replaced a broken headlight and turn signal.

208ss · Post by **208ss** » Tue Mar 04, 2014 5:14 am

Ordered whiteline front 22mm swaybar and heavy-duty endlinks

CAV3MAN227 · Post by **CAV3MAN227** » Tue Mar 04, 2014 7:11 am

-I've only seen my gas light come on once in over 5 years I've owned the car and that was only because I was low on fuel and on an incline on a driveway. Never seen it since.

-Joe

James614 · Post by **James614** » Tue Mar 04, 2014 8:22 am

Killed it, somehow. Died while idling, wouldn't start backup. Has two codes for MAP and IAC but I think those are stored. I really hope its the fuel pump.

208ss · Post by **208ss** » Fri Mar 07, 2014 8:06 pm

Installed my whiteline swaybar and endlinks

James614 · Post by **James614** » Fri Mar 07, 2014 11:02 pm

Just had an Exedy LW flywheel and Stage 1 Clutch delivered. Now I can hopefully get to 15psi without slipping

James614 · Post by **James614** » Sun Mar 09, 2014 12:03 am

Installed my flywheel and clutch. I really wish I had just followed the FSM instead of winging it, then I may have realized you have to remove the clutch fork pivot shaft and take the fork out of the release bearing before the trans will come out

Edit: I really want to switch to the '06+ push style turbo trans now.

dankberries · Post by **dankberries** » Tue Mar 11, 2014 3:33 am

Installed a new torque converter seal today and put the engine in. I was in such a rush to pull the engine I had completely forgotten about removing the torque converter and damaged the seal when pulling the engine, also made for one hell of a mess with stinky atf every where. BTW I absolutely hate auto trannys! I'm so pissed I'm putting this back together w/ the auto. 5speed soon!

killajamal · Post by **killajamal** » Tue Mar 11, 2014 5:19 am

@Robertpaige your sedan looks f***ing rad my friend! Love it! So clean. What suspension you running?

208ss · Post by **208ss** » Tue Mar 11, 2014 4:26 pm

Got one of my wrx seats installed

jamal · Post by **jamal** » Wed Mar 12, 2014 8:45 am

James614 wrote:Installed my flywheel and clutch. I really wish I had just followed the FSM instead of winging it, then I may have realized you have to remove the clutch fork pivot shaft and take the fork out of the release bearing before the trans will come out

Edit: I really want to switch to the '06+ push style turbo trans now.

No you don't. I had my clutch fork crack at the pivot last year which was not fun to replace. It's pretty common on the newer WRX.

Also you can detach the throwout bearing from the pressure plate with a long screwdriver instead of pulling the pin.

turbo970 · Post by **turbo970** » Thu Mar 13, 2014 2:28 am

got rid of the fart can muffler and got the obx muffler put on

Danny-G · Post by **Danny-G** » Wed Mar 19, 2014 5:18 am

New wipers all around, wagon has been treating me pretty well overall.

208ss · Post by **208ss** » Thu Mar 20, 2014 3:59 am

found out that my transmission is going out the rear bearing is whineing like a mofo

killajamal · Post by **killajamal** » Thu Mar 20, 2014 8:40 pm

Turbo front end conversion. Plastidipped my hood, painted the front bumper, license plate hard-delete, custom front grill(inspired by the newer forester grill look) and blacked my lights and corners.

208ss · Post by **208ss** » Sat Mar 22, 2014 6:34 pm

Bought a ppg straight cut gear transmission because my stock went out.

CAV3MAN227 · Post by **CAV3MAN227** » Sun Mar 23, 2014 2:03 am

-Put some new tires on the car. Re-arranged some electronics in the cabin.

-Joe

94EJ22 · Post by **94EJ22** » Sun Mar 23, 2014 2:51 am

Got new rims put on, changed the oil and ran it through a car wash.

James614 · Post by **James614** » Sun Mar 23, 2014 12:36 pm

jamal wrote: Also you can detach the throwout bearing from the pressure plate with a long screwdriver instead of pulling the pin.

I tried this, there was no way a screw driver would fit in there at the angle we needed. But after the first try its cake undoing the fork in the future.

mike-tracy · Post by **mike-tracy** » Sun Mar 23, 2014 5:17 pm

208ss wrote:Bought a ppg straight cut gear transmission because my stock went out.

Did you buy the 4.44 tranny that had been for sale forever on nasioc? Considering the parts and labor put into it, that was a steal!

CAV3MAN227 · Post by **CAV3MAN227** » Mon Mar 24, 2014 1:39 am

-Painted a manifold, ready to go on tomorrow.

-Joe

dillonr92 · Post by **dillonr92** » Mon Mar 24, 2014 4:37 pm

Over the last month ive done all this.
I installed coil overs.
New catless TBE straight pipe.
Did a compression test.
Throttle body coolant bypass.
Installed a different maf.
Cleaned that maf.
Cleaned the iacv.
Installed td04/tmic..

Next up is water pump and timing belt and a few seals.
Then I have a five speed swap that needs to be done.
And the last thing I have on my to do list is pick up these headlight housings my buddy has. And clear the lenses, paint the housing black and then retro fit them.

Sent from my SCH-I545 using Tapatalk

Post by **Legacy777** » Mon Mar 24, 2014 6:15 pm

Please remember to hit return after each picture so the pictures scroll veritically vs. horizontally out to the side.

I fixed these.

Thanks

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?

Re: What did you do to your Subie today?